VPI HW-19 MK-4 Manual de Instruções descarregar pdf (Página 3)

diameter) groove. Replace the Motor Cover Plate. Make sure each post has a lock

washer atop it before putting the Cover Plate in place. Making the caps finger-tight is all

that is required.

MOUNTING THE TONEARM

• If you have a pre-cut arm board: Confirm that it is the correct board for the arm you are

mounting. Fasten the tonearm to the board according to its manufacturer’s directions.

• Attach the tonearms cable according to its maker’s directions.

3/16”

WOOD FRAME

SORBOTHANE

STARTING THE JR FOR THE FIRST TIME

• The JR’s on/off switch is on the left front of the base’s “skirt.” It is a push-push type

switch with two positions, “in” and “out.” Push it a couple of times and make sure that it

is in the “out” position.

• Plug the JR into an outlet that provides the required voltage as indicated on the carton.

• Depress the on/off switch. The turntable should start and come up to speed. Please note

that the JR is not a broadcast turntable and does not come up to speed within one

revolution. The type of high-torque motor that is required for such a rapid start would

degrade the audio performance of the turntable.

• In the unlikely event that the motor does not start, first check to make sure that the wall

outlet is “live” by plugging in a lamp or some other device known to be working. If the

outlet is live and the JR does not work, please contact your dealer or the factory for

advice and needed repair.

• NOTE: The motor will take from 5-6 hours to “break in.” In other words, the JR’s

performance will subtly improve during this time as the motor bearings reaches their

operating norm.

• Place the JR on the shelf on which it will be used. With the turntable running at 33, the

belt will run parallel to the chassis and within the middle 1/3 of the platter. You do not

have to be fanatical about this, leveling by eye is sufficient. However, if you do want to

be a fanatic, put a bubble level on the platter. Center the bubble by rotating the base’s

rubber feet to raise or lower each corner as needed.

1 2 3 4 5 6 7

Sem comentários

VPI HW-19 MK-4 Manual de Instruções Página 3