VPI Classic 2 Manual de Instruções

VPI Classic 2 Turntable Setup and Instruction Manual VPI Industries, Inc., 77 Cliffwood Ave. #3B, Cliffwood, NJ 07721 phone: 732-583-6895

9 Set the arm height as follows:  Start the turntable and place a record on it. Lower the arm onto the record and make the arm tube parallel to th

10  Place the rubber washer on the platter spindle, then the record on the platter, then screw the clamp onto the spindle. The clamp

1 Important: Read Before Proceeding!  Read and follow the Safety Instructions below.  Save all packing materials. The Classic 2 should only be mo

2 Unpacking the Box The turntable and tonearm are packed very carefully to avoid damage during shipping. It is important that you save the packing ma

3  The platter bearing is lubricated; no additional lubrication is needed for at least one year. Remove the platter from the smaller

4 A. CARTRIDGE MOUNTING: FOR CARTRIDGES WITH THREADED MOUNTING HOLES:  Use the screws supplied by the cartridge manufacturer to mount the

5  Place the arm tube assembly on the lower bearing, taking care not to strain or damage the 4-color wire and Lemo connector. Place the arm in its

6  Place the arm back in its rest.  Without letting the cartridge move, tighten the screws holding the cartridge to the arm head. Make it tight,

7  The Classic 2 arm does not have a built-in tracking force gauge, but a Shure Stylus Force Gauge is supplied with your arm. F

8 E. ANTI-SKATING: REMEMBER: A 10.5” ARM NEEDS VERY LITTLE ANTI-SKATING FORCE  Anti-skating is one of the least understood forces acting on a t